180 in. / 15 ft. SILVER JACKET CLIP TYPE CHUTE CABLE180 in. / 15 ft. SILVER JACKET CLIP TYPE CHUTE CABLEThis cut-away view shows the Quality Construction with Solid Wire Core.
Quantity Your Price
1 $59.99

C91-180

180 in. / 15 ft. SILVER JACKET CLIP TYPE CHUTE CABLE


Provides 3" of travel.
Cut to desired finish length.

Made in the USA

To complete your installation, see our Cable Hardware section.


Clip Type Chute Cable

The Silver Jacket Premium 33 series parachute cable comes in the trademark silver color which compliments any paint color scheme. The final overall length maybe altered by cutting the exposed wire end if required.


Product specifications:
  • Grooved housing for Clip Type mounting on one end
  • 10-32 NF threaded rod on one end
  • Exposed 0.075" diameter solid stainless wire on one end
  • Provides a total of 3" of travel
  • Flexible housing measures only .325" outside diameter
  • Cable length is measured tip to tip

Popular uses include:
  • Parachute Releases
  • Shutoff Valves
  • Remote Battery Switches

Product Overview:

Solid wire core

 


The solid wire core cable is desirable in certain applications such as a chute release, or when attachment hardware dictates a wire end. Two sizes are available to choose from, final overall length may be altered by cutting the exposed wire end if needed.

Fitted with efficient dynamic seals and requiring very little effort; these lightweight cables have a full circle of reinforcement wires to protect and support the inner liner, influencing positive load transfer with minimal lost motion.

Ideal for any cable operated application that requires pushing or pulling, and very well suited for extreme use environments. This combination should be considered as an upgrade replacement for Teleflex Morse type cables.

Grooved housing on one end, conduit on the other end.


Rated at 50# pull and 40# push, intermittent loads may exceed these ratings considerably without failure. These recommended load ratings reflect a balance between maximum load and reasonable cable life.

These aren’t a flimsy garden equipment control cable that will let you down when you need it the most.


Measuring Tip: To determine the proper length for your application, measure the tip-to-tip cable length by using a flexible rule to snake through the actual intended cable route.


The Pro-Werks’ Silver Jacket Cables are proudly made in the USA.

Make the connection.

See our Cable Hardware section for the many mounting options available; including Cable Ends, Knobs, Handles. Watch the Video to learn more!


Customer Comments:

"My pulling tractor has four supercharged engines and I can depend on 12 Silver Jacket cables to control them with ease."
             As shared with us at the
PRI Show


"Wow! Silver Jacket cables are smooth as butter."
            
Another Satisfied Customer at the PRI Show




Q:

How do I measure for total cable length?

A:

Use a flexible ruler and snake it through the intended cable route. The cable length is measured from tip-to-tip of the attaching ends, not the cable housing mounting points.

 



Q:

My cable installation is close to the exhaust system. How do I protect it from the heat?

A:

When installing a cable in an excessive heat environment, incorporating a heat deflector shield with adequate air gaps between the heat source and the cable housing is recommended.

 


For the most efficient and longest cable operating life it is recommended to install the cable so the heaviest load is in a pulling motion whenever possible.
Chute Cable: C91-180
Retracted Length: 4.25 in.
Thread: 10-32
Diameter Mount Point: 0.25 in.
Extended Length: 7.25 in.
;