CB10
5/8-18 LEFT HAND MALE MILD STEEL ROD END
Hole Diameter 5/8 in.
Ball Width 0.750 in.
26 Degrees of Misalignment
Radial Load Capacity 9713 LBS
Increase quantity in your cart for additional savings.
The "C" Series consists of a low carbon steel body (zinc plated) and Alloy steel ball, heat treated and hard chrome plated. This construction allows the rod end body to carry a greater static load and offers greater misalignment capabilities.
What is Radial Static Load Capacity?
These loads are based upon the minimal mechanical properties of the design configuration of the stressed areas. The Operation Load Capacity of Aurora rod ends is based upon the Radial Static Load Rating. Appropriate safety factors should be utilized with the application. Full rotation assemblies up to 100 rpm should not exceed 10% of the radial static load.
What is Axial Load Capacity?
Axial static load is the force
that is applied through the
bore of the ball. Maximum
axial static load capacity
is recommended at 15%
of the radial static load for
Aurora two piece rod ends,
10% for three piece rod
ends.
What is Bearing Misalignment?
A rod end or spherical
bearings ability to
mis-align is measured by
the degree of angle the
ball can accommodate
without interference.
Degrees to Misalignment:
26°
Thread Depth:
1.625 in.
L.H. Threads:
5/8-18
Width:
1.5 in.
Inside Diameter:
0.625 in.
Height to Centerline:
2.625 in.
Overall Thickness:
0.75 in.
Thickness:
0.484 in.