CM12-12
3/4-16 RIGHT HAND MALE MILD STEEL ROD END - 0.755 in. ID HOLE
Inside Diameter 0.755 in.
Increase quantity in your cart for additional savings.
This 3/4-16 RH threaded rod end has a special .005" oversized hole
in the ball allowing it to easily accept a 3/4" diameter steering shaft.
What is Radial Static Load Capacity?
These loads are based upon the minimal mechanical properties of the design configuration of the stressed areas. The Operation Load Capacity of Aurora rod ends is based upon the Radial Static Load Rating. Appropriate safety factors should be utilized with the application. Full rotation assemblies up to 100 rpm should not exceed 10% of the radial static load.
What is Axial Load Capacity?
Axial static load is the force
that is applied through the
bore of the ball. Maximum
axial static load capacity
is recommended at 15%
of the radial static load for
Aurora two piece rod ends,
10% for three piece rod
ends.
What is Bearing Misalignment?
A rod end or spherical
bearings ability to
mis-align is measured by
the degree of angle the
ball can accommodate
without interference.
Base to Center:
2.875 in.
Thread Length:
1.75 in.
Thread:
3/4-16
Head Diameter:
1.75 in.
Ball Width:
0.875 in.
Head Width:
0.593 in.
Ball Bore:
0.755 in.
Degrees of Misalignment:
24°