Ultimate Bulkhead / Clip Combo Cable
The Silver Jacket Ultimate cable is capable of tight radius bends with minimal resistance. As the Silver Jacket name implies, these 33 series cables come in the trademark silver color - that will compliment any paint color scheme.
Popular uses include:
- 7/16-20 NF threaded mounting bulkhead on one end
- Grooved housing for Clip Type mounting on one end
- 10-32 NF threaded rod on each end
- Provides a total of 2" of travel
- Flexible housing measures only .325" outside diameter
- Cable length is measured tip to tip of the 10-32 NF rods
- Conveniently sized in 6" increments
- Throttle Controls
- Shutoff Valves
- Parachute Releases
- Shifter Hookups
- Remote Battery Switches
Armored multi-strand core
The unique flat winding around the multi-strand, stainless steel core is part of the inner secret to the Silver Jacket Ultimate cable’s superior performance.
This construction delivers in the best of both worlds; flexibility of a multi-strand core with the smooth and consistent responsiveness of a solid wire core.
Fitted with efficient dynamic seals and requiring very little effort; these lightweight cables have a full circle of reinforcement wires to protect and support the inner liner; influencing positive load transfer with minimal lost motion.
Maximum Flexibility - Smooth Operation
Ideal for any cable operated application that requires pushing or pulling, and very well suited for extreme use environments. This combination should be considered as an upgrade replacement for Teleflex Morse type cables.
Threaded housing on one end, Grooved on the other end.
Rated at 60# pull and 50# push, intermittent loads may exceed these ratings considerably without failure. These recommended load ratings reflect a balance between maximum load and reasonable cable life.
These aren’t a flimsy garden equipment control cable that will let you down when you need it the most ...
Here's another bonus that you’ll appreciate; Silver Jacket Cables are available in 6" increments,
so you can affordably get a length that you need for a proper fit!
To determine the proper length for your application, measure the tip-to-tip cable length by using a flexible rule to snake through the actual intended cable route.
For additional information, watch the Video below to see all the Silver Jacket Cables in action !
Pro-Werks Silver Jacket Cables are proudly Made in the USA.
Make the connection.
Click this image to see the many mounting options available; including Cable Ends, Knobs, and Handles.
"My pulling tractor has four supercharged engines and I can depend on 12 Silver Jacket cables to control them with ease."
– As shared with us at the PRI Show
"Wow! Silver Jacket cables are smooth as butter."
– Another Satisfied Customer at the PRI Show
How do I measure for total cable length?
|Use a flexible ruler and snake it through the intended cable route. The cable length is measured from tip-to-tip of the attaching ends, not the cable housing mounting points.
My cable installation is close to the exhaust system. How do I protect it from the heat?
|When installing a cable in an excessive heat environment, incorporating a heat deflector shield with adequate air gaps between the heat source and the cable housing is recommended.
For the most efficient and longest cable operating life it is recommended to install the cable so the heaviest load is in a pulling motion whenever possible.
7/16-20 Both Ends
10-32 Both Ends
Diameter Mount Point:
10-32 Both Ends