Pull with Confidence
Pro-Werks Silver Jacket Drag Chute Cable Kit includes
everything needed for installing a cable release system for a
This kit includes a 15 foot Silver Jacket Premium 33 series chute
control cable, a CNC machined aluminum release lever, clevis end, cable mounting hardware, and weld-on tabs.
The Silver Jacket Premium 33 series parachute cable comes in the trademark silver color which compliments any paint color scheme. The final overall length maybe altered by cutting the exposed wire end if required.
- Grooved housing for Clip Type mounting on one end
- 10-32 NF threaded rod on one end
- Exposed 0.075" diameter solid stainless wire on one end
- Provides a total of 3" of travel
- Flexible housing measures only .325" outside diameter
- Cable length is measured tip to tip
Solid wire core
The solid wire core cable is desirable for chute release applications, the final overall length may be altered by cutting the exposed wire end if needed.
Fitted with efficient dynamic seals and requiring very little effort; these lightweight cables have a full circle of reinforcement wires to protect and support the inner liner; influencing positive load transfer with minimal
As the Silver Jacket name implies, these cables come in the trademark silver color which compliments any paint color scheme.
Grooved housing on one end, conduit on the other end.
This combination should be considered as an upgrade replacement for Teleflex Morse type cables.
To determine the proper length for your application, measure the
tip-to-tip cable length by using a flexible rule to snake through the actual intended cable route.
The Pro-Werks’ Silver Jacket Cables are proudly made in the USA.
Make the connection.
For additional information, watch the Video to see all the Silver Jacket Cables in action!
"My pulling tractor has four supercharged engines and I can depend on 12 Silver Jacket cables to control them with ease."
– As shared with us at the PRI Show
"Wow! Silver Jacket cables are smooth as butter."
– Another Satisfied Customer at the PRI Show
How do I measure for total cable length?
|Use a flexible ruler and snake it through the intended cable route. The cable length is measured from tip-to-tip of the attaching ends, not the cable housing mounting points.
My cable installation is close to the exhaust system. How do I protect it from the heat?
|When installing a cable in an excessive heat environment, incorporating a heat deflector shield with adequate air gaps between the heat source and the cable housing is recommended.
For the most efficient and longest cable operating life it is recommended to install the cable so the heaviest load is in a pulling motion whenever possible.
Diameter Mount Point:
0.188 in. 2 Places
Center To Center: